Talk About The Rolling And Cutting Process Of Titanium Plate

1, if the semi-automatic cutting, then the guide rail should be placed on the plane of the titanium plate, and then put the cutting machine on top of the guide rail, pay attention to the order can not be reversed. 2, the cutting parameters should be appropriate, should be based on the thickness of the titanium plate, etc. to be reasonably clear, in order to be able to get a good cutting results.
3, the cutting nozzle gas should be checked to see if it is smooth, if there is a blockage should be channeled in a timely manner.

4, titanium plate before cutting, the surface should be cleaned up, and there should be a specific space, which can facilitate the slag blowing out. 5, the distance between the cutting nozzle and the surface of the titanium plate should be suitable, too close and too far is not good.
6, preheating should be sufficient, so as not to affect the cutting process.
7, if cutting different sizes of workpieces, then you should cut the small pieces first, and then the large pieces.