What Are The Main Technical Requirements Of Gr1 Titanium Rods?

1:The chemical composition of gr1 titanium rods should be consistent with the provisions of GB/T 3620.1, the need for repeated testing, the allowable deviation of the chemical composition should be consistent with the provisions of GB/T 3620.2.
2: The diameter or length of the hot-worked bar and its allowable deviation should be in line with the provisions of Table I.

3: hot-worked by turning (grinding) light bars and cold rolled, cold-drawn bar diameter tolerance should be consistent with the provisions of Table II.

4: hot machined by turning (grinding) light bars should not be more than half of its dimensional tolerance of the out-of-roundness.

5: Processing state of the bar is not a length of 300-6000mm, annealed state of the bar is not a length of 300-2000mm, fixed or times the size of the length should be within the length of not a length. Allowable deviation of fixed length is +20mm; times the length of the bar should also be counted in the amount of the cut, each cut amount of 5mm. fixed or times the length should be specified in the contract.

CHEMICAL COMPOSITION OF TITANIUM GR 1 ROUND BAR

MECHANICAL PROPERTIES OF TITANIUM GR 1 ROUND BAR

PHYSICAL PROPERTIES OF TITANIUM GR 1 ROUND BARS